VR80 Anti-walk hammer and trigger pin kit

$29.99
(4 reviews) Write a Review
VR80 Anti-walk hammer and trigger pin kit

Hayes Custom VR80 anti-walk hammer and trigger pin kit

We have removed all screws from the hammer pin design, thus eliminating the need for thread locker.  

  • Eliminates the possibility of the hammer and trigger pin walking out
  • Works on Elftmann (drilling required), Tooth and Nail and factory hammers
  • Comes with 2 pins, 5 E clips, and drill bit

Fitting will be required if using the Elftmann trigger. You will need to drill out the threads in the hammer with the provided drill bit.  

Short pin is for the trigger and long pin is for the hammer

** Altering hammer and trigger may void the factory warranty**

4 Reviews Hide Reviews Show Reviews

  • 5
    Must have Anti-walk pin kit

    Posted by Andrew on May 1st 2021

    This is a must have hammer and trigger pin set for your VR80. If you've done any kind of trigger work, or just taken it apart to clean— this kit is highly recommended to replace the stock pins. Once you remove the stock pins— particularly the trigger pin... it will tend to creep out on you while you're shooting; even if you add blue loctite. This Hayes kit with the end-clips will keep everything secure. They're finely made, and very high quality. They were a perfect fit for my new flat-face trigger. Easy to install. And they look really good on the rifle. Get these now!

  • 5
    Absolute must for VR80!

    Posted by Tyler H. on Apr 22nd 2021

    This is a must have upgrade for the trigger system in the VR80. I had the elftman and my trigger screws kept walking out, even when locktite was used... this solved the problem and the trigger runs flawlessly.

  • 2
    Did not fit as advertised

    Posted by Mitchel Chauvie on Feb 12th 2021

    I NEVER write bad reviews but in this case others need to know that if you have a Tooth and Nail trigger set the anti - walk hammer pin from this set will not fit unless you drill it. I only bought this set because they advertise no drilling is necessary. So 50% of this set is drop in.

  • 5
    VR80 PINS

    Posted by Phil Underwood on Sep 25th 2020

    A must have upgrade for your VR80 if you have installed aftermarket trigger.. quick and easy install A+