Noveske flush QD sling mount

$20.00
(1 review) Write a Review

Flush QD Mount for plastic stocks or handguards. 
-Steel QD mount and nut 
-Low-Profile 
-4 Position, rotation limited 
-Can be mounted in most hollow plastic stocks 
-Uses standard QD Swivel (Not included) 
Weight: 0.3oz 

The Flush QD Mount can be installed in most plastic stocks that are hollow and handguards that have a relatively flat section. 
Installation requirements 
-A 1/2" hole must be drilled 
-Material thickness of less than 1/4" 
-5/8" wrench 
-QD Swivel 
-Permanent thread locker is recommended

1 Review Hide Reviews Show Reviews

  • 5
    Noveske Fluch QD Sling Mount

    Posted by KC on Jun 11th 2020

    Installed yesterday on HTA 90/22. Working just fine, so far. Easy install. Vendor should make some solution to tighten from the surface side, like 2 notches and a small device so that the square nut can be held in place and tightened from the top. But, all good so far.